GC Fuji PLUS — Resin-Modified Glass Ionomer Luting Cement

GC Fuji PLUS is a premium resin-modified glass ionomer (RMGI) luting cement that combines the chemical adhesion of glass ionomer with the strength of resin technology. Designed for reliable, long-lasting cementation of indirect restorations, it bonds directly to dentin, enamel, and cementum — eliminating the need for complex bonding procedures and minimising post-operative sensitivity.

Its smooth, creamy consistency and ultra-low film thickness (~10 µm) ensure precise, complete seating of crowns, bridges, inlays, onlays, and posts. The snap-set characteristic allows easy excess cement removal approximately 60 seconds after placement — making clinical procedures faster and more predictable.

Key Features

• Strong chemical adhesion to dentin, enamel, and cementum
• Reliable bonding to metal, resin, and silanated porcelain restorations
• Ultra-low film thickness (~10 µm) for accurate seating
• Snap-set — easy excess removal ~60 seconds after placement
• Moisture tolerant during placement for predictable results
• Continuous fluoride release for secondary caries protection
• Radiopaque for clear radiographic identification
• Very low solubility for long-term marginal seal integrity
• No post-operative sensitivity

Indications

• Cementation of metal, PFM, and resin crowns, inlays, onlays & bridges
• Cementation of porcelain inlays
• Cementation of prefabricated pins, posts and cast posts
• Cementable reinforced all-ceramic crowns and bridges (e.g. Procera)

Specifications

• Type: Resin-Modified Glass Ionomer Luting Cement
• Powder: Alumino-Silicate Glass (~99%)
• Liquid: HEMA 25–35%, UDMA <10%, Polyacrylic Acid 20–30%, Distilled Water 20–30%
• Powder:Liquid Ratio: 2.0:1.0 (g/g)
• Mixing Time: 20 seconds
• Working Time: 2 min 30 sec at 23°C
• Final Finishing: 4 min 30 sec after seating
• Film Thickness: ~10 µm
• Shelf Life: Powder 3 years | Liquid 2 years
• Storage: 4°C – 25°C
• Pack Contents: 1 x 15g Powder | 1 x 8g (7ml) Liquid | 1 x 7g (6.5ml) Conditioner

Directions for Use

1. Step 1 — Preparation: Clean the prepared teeth carefully. Apply Fuji PLUS Conditioner for 20 seconds for increased retention. Rinse and gently dry.
2. Step 2 — Mixing & Application: Mix Fuji PLUS for 20 seconds. Coat the internal surface of the restoration with ~1mm of cement and seat within 30 seconds.
3. Step 3 — Excess Removal: Remove excess cement when the gel stage begins to form (~1 minute after seating).
4. Step 4 — Final Set: Maintain isolation until final set is verified (~4 minutes).

For professional dental use only.